Digital Voice Systems AMBE-3000 Specifications Page 82
- Page / 111
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
AMBE-3000F™ Vocoder Chip Users Manual
Version 3.4, April, 2014
Dat
a and Configuration Packets
PKT_VERSTRING Response Field - Format
Field Identifier Response Field Data
1 Byte varies <= 48 Bytes
0x31 Version Data
Table 70 PKT_VERSTRING Response Field
PKT_READY field (1 byte total) a packet containing this field is output by the AMBE-3000F™ Vocoder Chip after a hard
reset (TQFP pin 113 / BGA pin D6) or packet reset (using a PKT_RESET or PKT_RESETSFTCFG field) when it is ready to
receive packets.
PKT_READY Field - Format
Field Identifier Control Field Data
1 Byte 0 Byte
0x39 No Data Needed
Table 71 PKT_READY Field
PKT_HALT field (1 byte total) this field will cause the AMBE-3000F™ Vocoder Chip to enter halt mode. In this mode the
AMBE-3000F™ Vocoder Chip will consume the least amount of power possible. The only way to exit this mode is to perform
a hardware reset.
PKT_HALT Field - Packet Format
Field Identifier Control Field Data
1 Byte 0 Byte
0x35 No Data Needed
Table 72 PKT_HALT Field
The PKT_HALT field does not return a Response field.
PKT_RESET field (1 byte total) this field will cause the AMBE-3000F™ Vocoder Chip to be reset. As a result, the AMBE-
3000F™ Vocoder Chip will lose all prior configuration settings and reset itself to the default power up state. Note that the
AMBE-3000F™ Vocoder Chip will re-read the configuration pins.
PKT_RESET Field - Format
Field Identifier Control Field Data
1 Byte 0 Byte
0x33 No Data Needed
Table 73 PKT_RESET Field
The PKT_RESET field does not return a Response field; however, the AMBE-3000F™ Vocoder Chip does output a
PKT_READY packet after every reset (including both hard resets and packet resets). The PKT_READY packet can therefore
be viewed as a response packet to the packet containing a PKT_RESET field.
PKT_RESETSOFTCFG field (7 bytes total) this field will cause the AMBE-3000F™ Vocoder Chip to be reset. As a result,
the AMBE-3000F™ Vocoder Chip will lose all prior configuration settings and reset itself to the default power up state. This
is similar to PKT_RESET; however the hardware configuration pins can be overridden by the settings specified by the packet.
The PKT_RESETSOFTCFG packet contains 6 additional bytes of data which specify the settings for the 24 configuration pins.
CFG0 – CFG2 specify the software settings for each of the 24 configuration pins. MASK0-MASK2 specify whether the
(Subject to Change) Page 72
DVSI CONFIDENTIAL PROPRIETARY
- AMBE-3000F™ Vocoder Chip 1
- DVSI Confidential Proprietary 1
- (Subject to Change) Page v 5
- (Subject to Change) Page x 10
- 1 Product Introduction 11
- 1.3 Typical Applications 12
- 2 Hardware Information 13
- 2.2 Package Details 14
- (Subject to Change) Page 5 15
- 2.3 Pin Assignment Layouts 16
- A B C D E F G H J K L M N P 17
- (Subject to Change) Page 8 18
- (Subject to Change) Page 9 19
- 2.5 Pin Out Table 20
- PARITY_ENABLE 79 22
- Input Enable parity bit 22
- Table 1 Pinout List 26
- 2.7.1 External Clock Source 29
- 2.7.2 Crystal Oscillator 29
- Table 7 Voltage Supply Pins 32
- 3.6 Reset Behavior 33
- Figure 11 TX_RDY after Reset 34
- Figure 12 Output Levels 34
- 3.8 Power-Down Sequencing: 35
- 3.9 Low Power Modes 35
- 3.9.1 Run State 36
- 3.9.2 Idle State 36
- 3.9.3 Standby State 36
- 3.9.4 Halt State 36
- 3.9.5 Power Modes 37
- 4.2 Interface Selection 40
- 4.4 Vocoder State 41
- Figure 18 Typical Echo Path 43
- Table 11 Companding Control 44
- 5 I/O Management 45
- Table 13 ECMODE_IN Flags 46
- Table 14 ECMODE_OUT FLAGS 46
- Table 15 DCMODE_IN Flags 47
- Table 16 DCMODE_OUT Flags 47
- 5.2 Codec mode 49
- “0 to Transition”“1” 51
- “Packet_ _Zone”Uncertainty 51
- “aperiodic packets” 52
- 5.3 Packet Mode 53
- Figure 29 Packet Mode 55
- 5.5 SPI Interface 56
- 5.6 UART Interface 57
- 5.7 McBSP Interface 58
- 5.8 Parallel Interface 61
- Table 26 PPT Timing 62
- Figure 36 Vocoder Front End 64
- Diagram 66
- 6.1 Overview 68
- 6.2 Codec Mode Operation 68
- 6.3 Packet Mode Operation 68
- 6.4 Packet Interfaces 69
- 6.5 Packet Format 69
- 6.5.3 TYPE (1 byte) 70
- 6.5.4 Packet Fields 70
- Table 59 PKT_CODECSTOP Field 78
- Table 61 PKT_CHANFMT Field 79
- samples dcmode 80
- Table 64 PKT_SPCHFMT Field 80
- 0x54 0x46 0x00 81
- Table 71 PKT_READY Field 82
- Table 72 PKT_HALT Field 82
- Table 73 PKT_RESET Field 82
- 6.7.1 Speech Packet Fields 89
- Table 100 CMODE Field Format 90
- Table 103 TONE Field Format 90
- 6.11 Example Packets 94
- 7 Appendices 98
- Table 115 Rate Index Numbers 100
- 8 Support 103
- Digital Voice Systems, Inc 104
- 10 IC Chip Software Errata 107
- Release 007 09/10/2009 108
- Release 014 08/31/2012 108
- 11 History of Revisions 109
© 2020, manymanuals.com. All rights reserved. | 1.097 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals